Table Assembly
Components Required
20 x M5x12mm BHCS
12 x M3x10mm SHCS
4 x TPU Feet (1)
4 x M5 Heat-set Insert
3 x Openbuilds 2080 Extrusion - 550mm
2 x Openbuilds 2040 Extrusion - 580mm
2 x Table Bolt Down Bracket A (2)
2 x Table Bolt Down Bracket B (3)
1 x Skirt Front A (4)
1 x Skirt Front B (5)
1 x Skirt Back A (6)
1 x Skirt Back B (7)
- Optional - print this part using the recommended settings!
- Print this part using the recommended settings!
- Print this part using the recommended settings!
- Print this part using the recommended settings!
- Print this part using the recommended settings!
- Print this part using the recommended settings!
- Print this part using the recommended settings!
Lay the 3 x 2080 extrusions next to each other length-ways, and attach the Skirt Front A and Skirt Front B using M5x12mm BHCS.
Tip
This is easiest to do upside-down!
Attach the Skirt Back A and Skirt Back B using M5x12 BHCS.
Slide the 2040 extrusions into the channels on either side of the skirt pieces.
Make sure they sit flush with the front and back of the skirts.
Install an M5 Heat-set insert into each table bolt-down bracket.
Use M5x12mm BHCS to attach the table bolt-down brackets to each corner of the electronics enclosure.
If you want to raise your table, now is the time to install your TPU feet using M5x30mm BHCS!
Fix the table to the Y axis of the mill using 3 corner brackets placed equispaced along both sides.
Congratulations!
You're to move onto your electronics and cabling! Head over to the Electronics Manual to get started!